Dry Moly Spray

Dry Moly Spray

Molyslip® DRY MOLY SPRAY is a high performance, resin-bonded, dry-film lubricant based on molybdenum disulphide. When applied to metal substrates the molybdenum disulphide forms a resilient, low friction film that protects against wear and corrosion. DRY MOLY SPRAY reduces metal pick-up and galling during component assembly and dry start-up conditions and where traditional ‘wet’ lubricants either cannot be used or do not provide adequate lubrication.

DRY MOLY SPRAY can be used in a wide variety of operating conditions – the applied film will operate between   -50°C and + 450°C without flaking or cracking. Unlike oils and greases the dry nature of the film will not attract dirt and dust and it is resistant to water wash-off making it ideal for use in extreme environments.


  • Low co-efficient of friction film provides outstanding protection against wear
  • Wide operating temperature range of -50°C to +450°C
  • Does not attract dirt and dust
  • Touch dry in under 1 minute allows components to be in service quickly
  • Prevents pick-up and galling


Shake well, hold can upright and spray from a distance of approximately 15-30cm. Coat the metal surface evenly and allow to dry. After spraying invert the can and spray until clear (failure to do this can result in valve blockage). If required burnish the surface with a lint free cloth after a minimum of 1 minute drying time.


Base oil viscosity
Drop point
Flash point (IP34)
Effective temperature range-50°C up to +450°C
Solidification point (of the base fluid)
Coefficient of friction (steel on steel, steady state)0.08

Request Safety Data Sheet

Need Help

Prefer speaking with a human to filling out a form? call us and we will connect you with a team member who can help.

+971 43395394

© Copyright by unadxb.com