Hylomar Universal Blue

SKU :

Pack Size : 100g

 

Category

Downloads

Share Product :

Description

Hylomar Universal Blue is a world-renowned, polyester urethane-based, non-setting and non-hardening gasket and jointing compound originally developed in partnership with Rolls-Royce.

Key Features & Specifications

• Temperature Range: Withstands extreme operating temperatures from -50°C to +250°C (-58°F to 482°F).
• Non-Setting / Non-Hardening: Remains permanently pliable, offering unlimited assembly time and making future component disassembly and cleaning fast and easy.
• Fluid Resistance: Highly resistant to automotive and industrial fuels, air, petroleum/synthetic diester lubricants, water, coolants, methanol/glycol mixtures, and turbine/piston engine combustion products.
• Vibration Resistance: Absorbs vibration and differential thermal expansion between mated components.
• Viscosity Grades: Available in Light, Medium, and Heavy grades depending on film thickness requirements (from 0.015 mm to 0.09 mm)

Application

• Automotive: Water pumps, oil pumps, inlet manifolds, timing chain covers, gearbox components, cylinder heads, and sumps.
• Industrial & Aerospace: Gas turbines, compressors, heavy machinery, electric motors, and defense equipment.
• Usage Methods: Can be applied directly to metal-to-metal or plastic-to-plastic joint surfaces to replace pre-formed gaskets, or used as a dressing to enhance the seal of traditional gaskets.

Direction to Use

• Clean the Surfaces. Ensure both joint faces are completely free of old gasket material, oil, grease, dirt, and moisture. • Apply the Compound. Spread a thin, even film or bead onto one or both mating surfaces. If using a pre-formed paper or cork gasket, coat both sides of the gasket thinly. • Allow Solvent Evaporation. Wait a few minutes (typically 5 to 10 minutes depending on ambient temperature) for the solvent carrier to evaporate until the compound turns tacky. • Assemble the Joint. Bring the components together and align them carefully. Do not apply in sub-zero temperatures. • Torque and Re-Torque Fasteners. Tighten bolts or studs to the manufacturer’s specified torque. Because the compound settles slightly under load, wait a few minutes and re-torque the fasteners to the required specification. • Wait Before Testing. If pressure testing the system, allow the assembled joint to sit for at least 30 minutes at room temperature (20°C to 25°C) beforehand.