Camp CleanWeld

• Wear Protective Gear. Always put on acid-resistant gloves, safety goggles, and a protective mask before opening the container. Work in a well-ventilated area. • Prepare the Surface. Ensure the welded stainless steel has cooled down to room temperature (below 40°C). Remove any heavy slag, grease, or dirt from the weld seam. • Mix the Gel. Stir the product thoroughly using a plastic rod or non-metallic tool to ensure an even consistency. Never use metal stirrers. • Apply with a Brush. Use an acid-resistant synthetic or nylon brush to apply an even, generous layer of the gel directly over the weld seam and the heat-affected zone. The gel is formulated not to drip on vertical surfaces. • Allow Dwell Time. Leave the gel on the metal to react for 10 to 60 minutes (up to 2 hours for heavy oxidation or thicker grades of steel). Do not let the gel dry out on the surface or apply it in direct sunlight. • Rinse Thoroughly. Wash the treated area completely using a high-pressure water jet or plenty of clean water until all chemical residue is gone. Collect and neutralize the runoff water according to local environmental regulations before disposal