Permatex The Right Stuff Black 1 Minute Gasket Maker 85224

SKU : 85224

Pack Size : 7.5 oz

12 Piece per Cartoon

Category

Downloads

Share Product :

Description

PERMATEX® The Right Stuff is a single component, room temperature curing, elastomeric gasketing compound designed to provide reliable “formed-in-place” gaskets for mechanical assemblies. The Right Stuff is a non-slumping, non-corrosive, low odor, low volatile, single component, proprietary, hi-tech, elastomeric rubber gasketing material. It has been designed specifically as a replacement for conventional cut gaskets where instant sealability is advantageous. The product resists aging, weathering and thermal cycling without hardening, shrinking or cracking. Designed for superior bonding properties to oil contaminated metals as compared to other formed-in-place gaskets, and maintains outstanding oil resistance. NSF White Book registered.

Application

• Timing gear covers
• Transmission pans
• Valve covers
• Oil pans
• Water pumps
• Gearboxes
• Intake manifold end seals
• Stamped sheet metal covers
• Compressors
• Gearboxes

Direction to Use

For assembly as form-in-place gasket 1. Remove all previous material from mating surfaces. Permatex Silicone Stripper is recommended for most materials. 2. For best results, clean and dry all surfaces with a residue-free solvent, such as Permatex Brake and Parts Cleaner. 3. Cut nozzle to desired bead size, 1/16“ to 1/4“ in diameter. An 1/8” bead is usually sufficient for most applications. 4. Remove cap, puncture tube or cartridge seal and attach extension nozzle. 5. Apply a continuous and even bead of The Right Stuff to one surface, first tracing the internal areas of the gasket configuration, then all surrounding bolt hole. 6. Assemble parts within 5 minutes while The Right Stuff is still wet. Secure or tighten to recommended torque specs. 7. Re-torque will not be necessary after the product has cured. Note: Not for use as a head gasket or on parts in contact with gasoline Directions for PowerBead 1. Clean and dry all flange surfaces to be sealed. 2. Remove black cap from top of extension nozzle. 3. Turn nozzle extension one complete turn (360°) counterclockwise. 4. Depress finger trigger and apply a continuous 1/16 inch to 1/8 inch PowerBead to one surface. 5. Assemble parts within 5 minutes while The Right Stuff is still wet. Secure or tighten to recommended torque specs. 6. Parts or vehicle may be placed back into service immediately. 7. Re-torque will not be necessary after the product has cured. 8. To close, turn extension nozzle clockwise until tight (about one full turn). Wipe off excess material from nozzle and replace black cap.