Permatex Optimum Easy-Disassembly Black RTV Silicone Gasket Maker 27037

For assembly as a form-in-place gasket 1. Remove all previous material from mating surfaces. Permatex® Gasket Remover is recommended for most materials, not for plastics or painted surfaces. 2. For best results, clean and dry all surfaces with a residue-free solvent, such as Permatex® Brake and Parts Cleaner 3. Cut nozzle to desired bead size, 1/16” to 1/4” in diameter. A 1/8” bead is usually sufficient for most applications. 4. Remove cap, puncture tube or cartridge seal and attach extension nozzle. 5. Apply a continuous and even bead of silicone to one surface, first tracing the internal areas of the gasket configuration, then all surrounding bolt holes. 6. Assemble parts immediately while silicone is still wet. 7. Finger tighten flange only until material begins to seep out the sides of the flange. 8. Allow to set for at least two hours and re-torque at least one quarter to one half turn. 9. For best results, allow to cure overnight. For assembly as a gasket dressing 1. Repeat steps 1 through 4 as in previous section. 2. Apply a thin film of silicone to one surface to be sealed. 3. Place the pre-cut gasket onto silicone film. 4. Apply a second thin film to pre-cut gasket surface. 5. Remove any excess and assemble parts immediately. Note: Product is not recommended for use as a cylinder head gasket or head gasket sealant. Storage of Unused Product 1. Create a “Silicone Plug” by allowing excess material to extend beyond the extension nozzle or aerosol tip to cure, sealing and protecting the remaining product from moisture. For reuse, simply remove the cured product from the tip. 2. For PowerBead dispensers, you may store remaining product using either the above “silicone plug” method or using the included plastic cap. For Cleanup 1. Remove uncured product from parts and hand-tools with Permatex Fast Orange Wipes or Fast Orange Hand Cleaners. If skinned over, break film with a dry cloth to remove as much as possible. Remove the remaining material with Permatex® Gasket Remover. 2. Clean hands with a dry cloth or Permatex Fast Orange Hand Cleaner.