Permatex Optimum Easy- Disassembly Grey RTV Silicone Gasket Maker 27036

SKU : 27036

Pack Size : 3 oz

12 Piece per Cartoon

Category

Downloads

Share Product :

Description

Permatex Optimum Grey is a single component, room temperature vulcanizing gasketing compound designed to provide reliable “formed-in-place” gaskets for mechanical assemblies. This material cures on exposure to moisture in the air to form a tough, flexible, silicone rubber gasket. The product resists aging, weathering and thermal cycling without hardening, shrinking or cracking. Permatex Optimum Grey is the most advanced high performance, high temperature (up to 700 F intermittent) RTV gasket available.

Application

• Pumps
• Compressors
• Exhaust manifolds/headers
• Valve covers
• Oil pans
• Thermostat housings
• Gearboxes

Direction to Use

For assembly as form-in-place gasket 1. Remove all previous material from mating surfaces. Permatex Silicone Stripper or Gasket Remover is recommended for most materials, not for plastics or painted surfaces. 2. For best results, clean and dry all surfaces with a residue-free solvent, such as Permatex Brake and Parts Cleaner. 3. Cut nozzle to desired bead size, 1/16 “ to 1/4 “ in diameter. An 1/8” bead is usually sufficient for most applications. 4. Remove cap, puncture tube or cartridge seal and attach extension nozzle. 5. Apply a continuous and even bead of silicone to one surface, first tracing the internal areas of the gasket configuration, then all surrounding bolt holes as shown below: 6. Assemble parts immediately while silicone is still wet. Secure or tighten to recommended torque specs. 7. Re-torque will not be necessary after the product has cured. For assembly as a gasket dressing 1. Repeat steps 1 through 4 as in previous section. 2. Apply a thin film of silicone to one surface to be sealed. 3. Place the pre-cut gasket onto silicone film. 4. Apply a second thin film to pre-cut gasket surface. 5. Remove any excess and assemble parts immediately. Note: Product is not recommended for use as a cylinder head gasket or head gasket sealant. Storage of Unused Product 1. Create a “Silicone Plug” by allowing excess material to extend beyond the extension nozzle or aerosol tip to cure, sealing and protecting the remaining product from moisture. For reuse, simply remove the cured product from the tip. 2. For PowerBead dispensers, you may store remaining product using either the above “silicone plug” method or using the included plastic cap. For Cleanup 1. Remove uncured product from parts and hand-tools with Permatex® Fast Orange® Wipes or Fast Orange® Hand Cleaners. If skinned over, break film with a dry cloth to remove as much as possible. Remove the remaining material with Permatex® Gasket Remover. 2. Clean hands with a dry cloth or Permatex® Fast Orange Hand Cleaner