Permatex High Strength Removable Threadlocker Orange 25210

1. Clean all threads (Bolt and Hole) with a cleaning solvent such as Permatex Brake and Parts Cleaner and allow to dry. 2. Determine if the threads to be bonded are Active or Inactive Metals . If material is an Inactive Metal, spray all threads with Permatex Surface Prep and allow 30 seconds to dry. Priming is not required if the material is an Active Metal. If unknown, it’s always best to use the primer. 3. Shake the product thoroughly before use. 4. To prevent the product from clogging in the nozzle, do not allow the tip to touch metal surfaces during application. 5. For Thru Holes, apply several drops of product onto the bolt at the nut engagement area. 6.For Blind Holes, apply several drops down female threads into the bottom of the hole. As threads are engaged, compressed air forces the product upwards into the threads 7. Assemble and tighten as usual. When tightening to established torque values, torque compensation is not required. For Cleanup 1. Residual liquid films and/or fillets outside the joint are readily soluble in Permatex Brake and Parts Cleaner. 2. Cured product can be removed with a combination of soaking in Permatex Gasket For Disassembly 1. Remove with standard hand tools. 2. In the rare instance where hand tools do not work, because of excessive engagement length, apply localized heat to nut or bolt to approximately 232C (450F). Disassemble while hot. For Reassembly 1. Remove loose product from nut and bolt. 2. Apply primer to all threads, regardless of metal type. 3. Assemble and tighten as usual