Loctite 641

For Assembly 1. For best results, clean all surfaces (external and internal) with a LOCTITE® cleaning solvent and allow to dry 2. If the material is an inactive metal or the cure speed is too slow, spray with LOCTITE® SF 7471™ or LOCTITE® SF 7649™ and allow to dry 3. For Slip Fitted Assemblies, apply adhesive around the leading edge of the pin and the inside of the collar anduse a rotating motion during assembly to ensure good coverage 4. For Press Fitted Assemblies, apply adhesive thoroughly to both bond surfaces and assemble at high press on rates 5. For Shrink Fitted Assemblies the adhesive should be coated onto the pin, the collar should then be heated to create sufficient clearance for free assembly 6. Parts should not be disturbed until sufficient handling strength is achieved For Disassembly 1. Apply localized heat to the assembly to approximately 250 °C. Disassemble while hot Clean-up 1. Cured product can be removed with a combination of soaking in a LOCTITE® solvent and mechanical abrasion such as a wire brush